Dual Hall Effect Sensors

Optimize your Hydraulic Motors and Pumps

Xensors’ Dual Hall Effect Sensors provide sensing solutions in demanding ambient conditions, from concept to design or fitted on later to enhance control and steering of any hydraulic equipment or machinery.

Dual Hall Effect sensors can sense speed and rotation at the same time. The sensor output is a frequency signal on channel A and a 90° phase shifted frequency signal on channel B allowing the Quadrature signal to determine rotation.

Their small contact surface, diameters as small as 12mm, allows them to operate at very high pressures. Available in various configurations, Xensor fits your application.


  • Two digital output signals 90° out of phase to each other
  • Detecting speed down to zero
  • Direction, forward and reverse, of ferrous targets
  • Constant amplitude square wave output
  • Wide speed range
  • Customize to the needs of your specific mechanical environment


  • Hydraulics
  • Turbines
  • Compressors
  • Transmissions

Dual Hall Effect Sensor

Typical Specifications
Supply Voltage Range
4.5 Vdc to 18 Vdc
Supply Current
18 mA max.
Output Type
Square Wave
Frequency Range
1 Hz to 15 kHz (inclusive)
Operating Tempurature
-40°C to 125°C